soap and soap cutters

Soap Cutters I build

Wednesday, September 15, 2010

This pattern is called "lost foam casting" in the photo below is the rough casting fresh out of sand.

Posted by lyndaves at 4:53 PM

lyndaves: retired from Freightliner Corp. on October 13, 2000 and never worked so hard in my life, like some damn fool kid

(no title)

Jacquelyn, this is your cutter with 3/4 " wire spacing.
cut soap

Raw bar or brick measures 14.25 X3.50 X 2.3/8 IN Right Brick cut into bars 18 1/2 hand bars of soap.
Pivot posts

Jacquelyn This is a before and after photo of your pivot posts. Using the LOST PH OME" method I cast these out of aluminum.
My Cutter 2

This cutter has a added feature, interchangeable cutter, the other cutter has a 5/8 spacing between wires. All wires are a D'Addario Gu...
cutting Bars

Cutting this bar with a half finished cutter. This cutter is has a wire spacing of 5/8 in.
Too much heat

Too much heat or to long on one side will do this.
Stage #1

This is how I started my Soap Cutter. Glued paper pattern onto the piece of wood for the scroll saw.
My Cutter

This Cutter is for me. Wire spacing is 1 1/16 , will cut a 18 in. bar 4 in. wide.
My Cutter 3

Created this cutter for cutting slab or multi bar molds like this ribbon mold. All cutters are $200.00 each.
Shrink wrapped with logo

With the ends pen you can add your logo and all the info required and on both sides if you like. Some exposure on the ends occurred after sh...

Picture Window theme. Powered by Blogger.